Gw-instek GDS-2000A series Quick start guide for Logic analy Manual do Utilizador

Logic Analyzer Option DS2-8LA and DS2-16A QUICK START GUIDE GW INSTEK PART NO. 82DS-23043M01 ISO-9001 CERTIFIED MANUFACTURER

Using the Bus Key The Bus key configures the UART, SPI, I2C or Parallel buses. 1. Press the BBUS key to access the Bus menu and to display the bus o

6. Press Event Table to view or save the decoded data in a list. 7. Press Edit Labels to create an on-screen label for the bus. I2C Bus The I2C bus

SPI Bus The serial peripheral interface (SPI) is a full duplex 4 wire synchronous serial interface. The word size is configurable from 4 to 32 bits. T

Parallel Bus The digital channels can be configured as a parallel bus. The number of bits that define the bus as well as which bit is used as the bus

Trigger Settings The Logic Analyzer option adds Bus and Logic triggers to the GDS-2000A. Note that the digital channels can also be set as the source

addition to the User-defined threshold setting (TTL, 5.0V CMOS, 3.3V CMOS, 2.5V CMOS, ECL, PECL, 0V).  Thresholds can be set for each 4 lots of dig

Bus Trigger Settings -UART The digital channels can be set up to trigger on UART specific conditions. 1. Configure the Bus key to UART.  The UART o

Bus Trigger Settings –I2C The digital channels can be set up to trigger on I2C specific conditions. 1. Configure the Bus key to I2C.  The I2C optio

SPECIFICATIONS Logic Analyzer Sample Rate 500MSa/s Bandwidth 200MHz Record Length 2M max /ch Input Channels 16 Digital (D15 - D0) or 8 Digital (D7~D0)

This manual contains proprietary information, which is protected by copyright. All rights are reserved. No part of this manual may be photocopied,

OVERVIEW The DS2-8LA and the DS2-16LA Logic Analyzer options allow the GDS-2000A to be upgraded to a powerful mixed signal oscilloscope. These options

Package Contents and Accessories Standard Accessories for DS2-8LA Item Part Number 8-Channel Logic Analyzer Probe GTL-08LA 8-Channel Logic Analyzer Ca

Display Overview Logic Analyzer Display Overview 624513 Description 1. Horizontal Position 2. Trigger Status 3. Horizontal Status 4. Bottom Menu

Bus Display Overview 9578461 2 3 Description 1. Bus Data 2. Start Bit 3. Stop Bit 4. Horizontal Position 5. Trigger Status 6. Horizontal Statu

Setting up the Oscilloscope This section describes how to set up the oscilloscope properly including installing the logic analyzer cards, using the lo

Using the Logic Analyzer Probes This section will describe how to connect the digital channels to the device under test. To use the digital channels t

Accessing the Logic Analyzer Menu The Logic Analyzer menu can be accessed using the Option key. 1. Press the Option key and select Logic Analyzer to