Gw-instek GLA-1000 Series Quick start guide Manual do Utilizador

Logic Analyzer GLA-1016/1032/1132 QUICK START GUIDE GW INSTEK PART NO. 82LA-11320MA1 ISO-9001 CERTIFIED MANUFACTURER

Tool bar Standard Group Create new project file. Open a project file. Save the project file. Print out the display. Trigger Group Configure

Windows group Waveform display mode. Listing display mode. Mouse pattern group Normal arrow mode. Area selection (Enclose) mode. Hand mode. S

Horizontal measurement bar Horizontal range Scale (upper line) shows the data acquisition clock frequency. Total (lower line) shows the total length

Software Installation and Power Up Requirements: Windows OS: XP Vista (Basic/other) 7 (32/64 bit) CPU: 300MHz 800MHz/1GHz 1GHz RAM: 256MB 512/1GB 1GB

4. Enter your user name and organization. Set the range of user access: All users or the user currently logged in. 5. Select the setup type: Compl

Power Up This section assumes that the Logic Analyzer software has already been installed. Hardware Connection: Connect the GLA and the PC via the US

3. If there is already a setup file (*.gla) being saved, the software asks whether to open it. 4. The display appears. Demonstration Mode You can

Functionality Check Hardware Connection: Connect GLA and the PC via the USB cable. Press the GLA power switch and make sure the power LED turns On. S

SPECIFICATIONS The specifications apply under the following conditions: GLA is powered on for at least 30 minutes, within +20°C~+30°C. General Specifi

Trigger GLA-1016 GLA-1032 GLA-1132 Channel 16 32 32 Condition Edge/Pattern Edge/Pattern Edge/Pattern Pre/Post trigger 0% ~ 100% 0% ~ 100% 0% ~ 100% L

This manual contains proprietary information, which is protected by copyright. All rights are reserved. No part of this manual may be photocopied,

Signal Statistics Positive/ Negative, Full cycle within length condition Positive/ Negative, Full cycle within length condition Positive/ Negative, Fu

SAFETY INSTRUCTIONS This chapter contains important safety instructions that must be followed when operating the GLA and when keeping it in storage. R

Cleaning • Use a soft cloth dampened in a solution of mild detergent and water. Do not spray any liquid into the GLA. • Do not use chemicals or clea

GETTING STARTED The Getting started chapter introduces the GLA main features, panel overview, display overview, installation and power up. Main Featu

environment • Fast communication: USB 2.0, 1.1 compatible • USB bus powered • Various file export: operation setting, waveform data, display image

Panel Overview and Display Panel Overview Start SwitchPowerLEDTriggerLEDReadLEDRunLEDPowerSwitchUSBConnectorInputConnector Item Description USB Conne

Start Switch Triggers signal capturing. This is the same functionality as the Single Run. button. Input Connector For Extension Module A0~D7 Signal

Display Overview Menu barBus/signal listTooltipData capture statusTool barHorizontal measurement barTrigger list Menu bar File operations. Bus/Sig